Used to make your own honey tanks.
Fitting the gate requires a hole in a bucket.
It is important to only use food grade plastic tanks.

Drill hole into bucket/tank.
Screw on honey gate to bucket/tank.
(screw the back of the honey gate onto the male thread. If done incorrectly, the O-ring will stretch and honey will leak)

ALWAYS TEST HONEY GATE FOR LEAKAGES FIRST BEFORE PLACING HONEY IN THE TANK
To do this close the gate and fill bucket/tank with water. (fill up to just above the honey gate)
Open and close the gate a couple times. This should then show if the gate has leaks.
To fix you will need to adjust the nuts on each side to balance it out.
Once this is fixed you are now able to put honey into it. (this can happen with any honey gate)

40mm Diameter to drill into bucket.
O-ring perished and need a new one?
Ask our staff about replacements.